Sentence examples for inlet surface from inspiring English sources
Poor operation performance was experienced due to inlet surface plugging and in some cases limited structural robustness under uncontrolled regeneration conditions.
The better results obtained with the radial column were probably the consequence of the geometrical design of this device (larger inlet surface area and small outlet surface area which concentrate the eluted fraction).
The frequency response of the tube was defined as the ratio of the complex amplitude of the collector current to the complex amplitude of ion concentration at the inlet surface K( jω)=Ic( jω)/n( jω).
The Farafra model which uses a courtyard can achieve at the inlet surface 1 1.2 m/s (33 41% of wind velocity) which is less than the required indoor air velocity for comfort.
The addition of an inlet surface is then shown to increase significantly the power output of the heaving system whereas this design strategy is not equally beneficial for the rotational system.
We further study the effect of adding an inlet surface upstream of the mount as a means of changing the destabilising mechanism from single-mode flutter to modal-coalescence flutter which is a more powerful instability more suited to energy harvesting.
The results show that the Aswan model can achieve at the inlet surfaces (windward side of buildings) 1.8 2.4 m/s (60 80% of wind velocity) especially at the second and third rows of indoor air velocity which is the required indoor air velocity for comfort.
In this paper a methodology is presented by which the inlet lip surface is mapped to a rectangular grid system which is topologically similar to the surface to be blended.
The inlet lip surface blending needs to meet stringent conditions, which vary considerably from fore lip to aft lip.
To accurately simulate wind flow in the built environment, velocity profiles at the inlet boundary surface of the calculation domain must be accurately modelled.
Given the dominance of Gymnodinioid dinoflagellates in both our samples and that of Takahashi et al. [97] perhaps K. rotundum may belong to the 10 m Saanich Inlet winter surface dinoflagellate assemblage and deserves further investigation.
