Sentence examples for inlet heating from inspiring English sources

The system performance testing showed that the distillate production can reach 50 L/h at 80 °C of inlet heating water.

To elucidate the effect on the flow distribution, the following factors are investigated: vapour fraction at the manifold inlet, heating load on the heat exchanger tubes, diameter of the manifold and manifold inlet tube length.

Furthermore, the effects of different inlet heat transfer fluid flow rates and temperatures on the PCM melting/solidification time are demonstrated in this study.

Based on the model, effects of inlet heat transfer fluid temperature and flow rate on thermal performance of the unit are discussed in the cold charge process.

In this study, the steam reformer has a shell and tube configuration that is divided into the following zones: the inlet heat exchanging zone, the reforming zone and the exit heat exchanging zone.

The optimal regions of the voltage output of the PV cell, the energy gap of the material in the PV cell, and the inlet heat flow of the gas pipe are determined.

The thermal efficiency is defined as the system useful power divided by the heat absorbed from the inlet heated fluid by the system's thermal regenerator: eta_{text{th}} = frac{{dot{W}_{text{net}} }}{{dot{Q}_{text{HRVG}} }}.

To make a comprehensive comparison between the conventional ESI-MS and the SPIN-MS interfaces, the inlet heated capillary temperature of the conventional interface was tuned separately at 300 °C for optimal sensitivity and at 150 °C for gentler ionization conditions using the tuning solution.

Heavy knock was deliberately induced by adopting inlet air heating and a primary reference fuel blend of reduced octane rating.

The transcritical cycle, with dehumidification of exhaust air at a constant temperature and inlet air heating in the supercritical region, is thermodynamically well-matched to the drying process.

The heat exchangers are tested using inlet air heated up to 750 °C on the hot side, room-temperature inlet air on the cold side, and flow rates up to 3 × 10−3 kg s−1 (150 standard liters per minute of air).