Sentence examples for inlet cross section from inspiring English sources

Different sets of boundary conditions are considered, including injections through inner and outer regions of the column inlet cross section.

When the inlet cross section was employed as horizontal, the performance of the collector was reduced by 84% compared to the vertical inlet setting, at 1.00pm.

To investigate the effects of solvent properties on interfacial area a small inlet cross-section was used.

Based on the CFD velocity data, fluid particles disposed on the inlet cross-section at a time were traced in the mixer with the aspect ratio of one.

For a fixed flow rate, the inlet cross-section has marginal effect on the interfacial area; however, the developed width of the rivulet remains unchanged.

Direct numerical computation of tone acoustic power is based on a RANS (Reynolds averaged Navier Stokes) solver followed by an integration of acoustic intensity over specified inlet cross-sections, derived from Cantrell and Hart equations (valid in irrotational flows).

It was found that when the inlet has vertical cross section, it offered the best performance as the velocity and mass flow rate of the air at the chimney was observed to be higher compared with the other three inlet configurations.

Results show that the channel cross section, inlet gas temperature, and reformer pressure have the largest effect on the reactor performance.

The cross section of inlet chambers are constant, convergent, and divergent along the streamwise direction, respectively.

Even though the boundary element method itself is a truly three-dimensional analysis tool, it has not been effectively used on large silencers due to the large inlet and outlet cross sections.

This was a result from the design, i.e. of ratio of inlet tube cross-section area to the sum of channel cross-section areas.