The experiments simulated a pipe rupture in a cooling plate of the HCLL TBM, injecting He from an injection valve connected to He-FUS3 loop.
A sample line (5) connected to the sample reservoir (not shown) carries the sample fluid to the injection valve (6) where it is injected into the flow of the inlet buffer.
The samples were injected onto a column using an injection valve, a model 7225i from Rheodyne (Cotati, CA, USA).
The samples were injected onto a column using an injection valve, Rheodyne Model 7225i (Cotati, CA, USA).
After hydrodynamic equilibrium was established, as indicated by a clear mobile phase eluting at the tail outlet, the sample solution (4.0 g in 50 mL of each phase) was injected into the separation column through the injection valve.
A) This plot shows the dependence of the injected volume on the opening time of the injection valve.
A Gilson 234 autoinjector (Villiers-le-Bel, France) equipped with a Rheodyne (Bensheim, Germany) six-port injection valve (different injection loops) was used to inject samples.
Samples were injected into the flow of DIW by a manual six-port injection valve (Rheodyne, USA) with a 0.6 mL sample loop volume unless stated otherwise.
Open the steam injection valve of stimulation well when the steam meets the experiment requirement, inject 600 mL high-temperature steam, and then close the valve to soak for 0.4 min.
The extracted solution containing DOC was loaded into the injection valve of the continuous flow manifold.
The microfluidic injector, made of poly(dimethylsiloxane) (PDMS), operates similarly to an HPLC injection valve.
