Sentence examples for injection of test from inspiring English sources

Microdialysis data were expressed as a percentage of basal dopamine values; basal values were the mean of three consecutive samples (differing from each other by <15%) taken immediately before the first injection of test compound or vehicle.

Two standard disposable 19 mm needles (Neofly, BOC Ohmeda AB,) with a diameter of 0.4 mm were used for injection of test substances and inserted to their full length into each of the masseter muscles guided by the 90° canal of the plastic plate.

At 5 and 30 min (compound 41 only) following intravenous bolus injection of test compound, mice (n=3 per time point) were placed under terminal anaesthesia with isofluorane.

At least one injection of a standard preparation (reference standard or internal standard) should be done before the injection of test samples and the retention time must be within predefined limits.

One hour after oral administration and 30 min after intraperitoneal injection of test compounds, mice were individually suspended by the tail from a horizontal ring-stand bar raised 30 cm above the floor using adhesive tape placed 1 cm from the tip of tail and positioned such that the base of their tail was aligned with the horizontal plane.

Gas chromatograph At the beginning of each day of use, the analyst should make sure that the GC system is functioning correctly by at least one injection of a standard preparation (reference standard or internal standard) before the injection of test samples, and the retention time must be within predefined limits.

In both groups serious adverse events were absent, only a few patients reported mild and short-lasting adverse events after the first injections of test substances.

In contrast to the original 'gold standard' method of constant intravenous infusion of inulin for determination of glomerular filtration rate [ 13], modern techniques use intravenous bolus injections of test substances and algorithms for fitting of bi-exponential functions to the temporal concentration profiles observed.

Inside each satellite, the injection of the test masses from the caged configuration into the geodesic trajectory will be performed by the grabbing positioning and release mechanism.

In the LISA Pathfinder mission, the grabbing positioning and release mechanism will perform a critical phase, which is the injection of a test mass into a perfect free-fall condition (also called geodesic trajectory).

The response time is defined as the time required for the resistance to reach 90% of the equilibrium value following an injection of the test gas, and the recovery time is the time necessary for the resistance to return to 10% above original resistance in air after the removal of the test gas [10].