Sentence examples for injection loading from inspiring English sources

Through the use of an injection loading technique, a homogenous FCG scaffold was developed.

Summarizing two key studies (von Eckardstein and Nieschlag 2002; Schubert et al 2004) the following administration regimen is recommended for TU therapy in hypogonadal men: After the first injection of 1000 mg TU, the second injection of 1000 mg TU is to be administered 6-weeks after the first injection (loading dose) followed by injections every 12-weeks.

The model is implemented in Newton Raphson current injection load flow method (NR-CIM).

The injection load was higher than the column capacity, which did not enable to obtain a suitable separation.

This paper proposes an easy modelling of interline power flow controller (IPFC) into Revised Newton Raphson current injection load flow method.

It was found that changing the UV detection wavelength from 215 to 235 nm simplified sample preparation by allowing for an approximately fivefold increase in injection load while maintaining the signal within the linear range of detection.

The first two BAPTA injections loaded the cell to give an estimated BAPTA concentration of 9 μM.

Previous recordings of intracellular Ba2+ and Ca2+ recoveries after injection or loading by depolarisation [8,19] support the assumption that essentially all the unsequestered divalent cation load is pumped out by the PMCA, within 1 2 min of the end of the injection or depolarisation.

The algorithms for particle injection, particle loading, particle motion, and particle tracking are presented.

Boundary conditions and the algorithms for injection, particle loading, particle motion, and particle tracking are implemented for unstructured Delaunay grids.

The algorithms for injection, particle loading, particle motion, and particle tracking are parallelized for unstructured tetrahedral grids.