Sentence examples for injection height from inspiring English sources
The operational conditions were adjusted through moisture content in waste, excess air, litter ratio, secondary air and its injection height.
While regeneration energy of aqueous amine increased with an increase in flue gas temperature and stripper pressure, it decreased with an increase in injection height of absorbent.
Furthermore, it was found that porosity, vertical permeability, and bulk volume size did not have a noticeable effect on injection rate, while injection height from reservoir top, injector length, and amount of solvent in the mixture significantly influenced injection rate.
The injection height was calibrated using the first embryo by moving the needle downwards through the chorion until touching the yolk (400 µm above injection point).
To this end we increased the emissive layer thickness and decreased the device emissive area and we also performed engineering of the cathode interfaces through the incorporation of solution processed porphyrin interlayers in order to lower the electron injection barrier height.
Therefore, the establishment of the interfacial dipole or interface modification induces lower work function of ITO, which may reduce the electron-injection barrier height compared to the case without interface modification.
The contact resistance between the source/drain electrode and the active layer, and the electron-injection barrier height from the active layer to the interfacial gate insulator layer could explain this finding.
The treatment significantly affected the post-injection disc height (two-way repeated ANOVA, P <0.001).
The focus is on the momentum injection and cube height on the fluid dynamical parameters represented by the surface pressure, drag and side force.
The collection and processing of the gas chromatographic data were done using the Atlas software through a chromatographic server, which generated the respective gas chromatograms and the corresponding gas injection reports containing peak heights and areas.
We present the fabrication process for injection molded multi-height surface structures for studies of wetting behavior.
