Sentence examples for injection glass from inspiring English sources

The design and size of the needle utilized in the new fiber assemblies is discussed here, as well as the use of a septum-free injector replacement and a low-volume direct injection glass liner placed in the GC inlet.

For intrahippocampal injection glass pipettes with a tip diameter of about 30 µm were filled with activated particle solution and inserted into the hippocampus through a 0.5 mm diameter hole in the skull.

A direct injection glass liner (1 mm Uniliner® for 0.32 and 0.53 mm ID columns, 1.0 mm ID, 6.3 mm OD ×78.5 mm, Restek) was installed in the collection port as an interface adaptor between a separation column and the collection traps.

Double-stranded RNAs (200 ng) or elution buffer vehicle was injected into the hemocoel using pressure injection via glass microcapillaries.

The multivariate model showed the following to be predictors of HCV infection: age, injected drug use (OR = 6.65), sniffed drug use (OR = 2.59), hospitalization (OR = 1.90), groups socially deprived by the lack of sewage disposal (OR = 2.53), and injection with glass syringe (OR = 1.52, with a borderline p value).

In the present survey, a history of previous hospitalization and use of injections with glass syringe not related to drug use were also associated with HCV seropositivity, both of which have been widely reported as epidemiological risk factors for HCV infection worldwide [ 1, 2].

Subsequently, plasmid solution was injected via a pulled out glass injection capillary connected to a Hamilton syringe.

On their fourth day after repletion and dropping from the host mammal, engorged nymphs or females were weighed and then injected under a dissecting microscope with a locally-fabricated injection apparatus and glass capillaries that had been pulled with a Sutter needle puller.

(a) Autonomous embryo injection system by glass micropipette [18].

The figure illustrates gas water contact changes before and after gas injection into the glass slides.

Injection molded 20% glass fiber reinforced polypropylene leaf springs were considered for the joint strength evaluation.