Sentence examples for injection cap from inspiring English sources

The mixture was placed into a glass bottle fitted with a silicone rubber injection cap and this bottle was placed in a water jacket connected to a circulating water bath maintained at 35°C with rapid mixing until diethyl ether removed.

Hypodermic blind needles capped with Luer-lock injection caps were inserted into the external end of the catheter.

To examine whether of NF-κB directly regulates Slug and Snail RNA levels, we first characterized the effects of RelA and RelAΔSP in animal caps; injection of RelA RNA lead to an increase, while RelAΔSP RNA lead to a decrease in Slug RNA levels (FIG. 7A).

The supernatants were removed and transferred to 0.25 mL polypropylene injection vials with caps for each chromatography run.

Recently we reported that intratumoral injection of a short CAP, LTX-302, derived from the naturally occurring CAP bovine lactoferricin (LfcinB), leads to a local inflammation followed by a complete regression of the tumor.

The purpose of these images was to confirm the presence or absence of any residual Ra activity in syringe or syringe cap after injection and to assess any gross extravasation of Ra at the IV injection site.

Acute CO injection also suppressed the CAP significantly, but the effect was far smaller, occurred later in time, and lasted longer than the effect of KCN.

Injection of 50 pg capped npnt mRNA rescued the AV extension in a subset of MO2-injected embryos (Fig. 3E,F) and had only a minor effect on cardiac development when injected alone (88±1.5% normal hearts; Fig. 3F).

In addition, injection of 50 pg capped npnt mRNA markedly reduced the severity of the AV canal defect in the remaining embryos, with defective hearts showing an increase in type I defects (from 23.6±1.2%too 48.7±2.4%) and a decrease in type II defects (from 60±1.1% to 26.5±2.6%) (Fig. 3G).

Products include blow-molded bottles for milk and household cleaners; blow-extruded grocery bags, construction film, and agricultural mulch; and injection-molded pails, caps, appliance housings, and toys.

For the large column experiments, complex conductivity measurements were acquired using a four electrode configuration, with one electrode installed inside each end cap for current injection and two installed in the middle of the columns for measurements (Figure 2).