This avoids "identification" problems -- who says that a bottle of champagne is less "food" than a bottle of milk, or an injection of Botox is less "medicine" than an injection of antibiotics?
Respondent 8: Now they just do it with the bottle (drip)….. in the hospital they give the drip and injection so the delivery happens normally.
CCl4 was dissolved in olive oil (1 : 1 v/v) and cisplatin was used directly from a bottle for injection (50 mg/100 mL) without further dilution.
A tough plastic that is resistant to flame, electricity, and attack by most chemicals, PVDF is injection-molded into bottles for the chemical industry and extruded as a film for electrical insulation.
Figure 2a shows the experimental setup composed of the 2-L reactor, a mechanical stirrer, a 500-mL bottle containing the injection solution (TOPSe, ODE) and a Watson-Marlow 620 DI/RE peristaltic pump (Watson-Marlow and Bredel Products, La Queue Lez Yvelines, France) on the right, capable of injecting up to 500 mL within 3.5 seconds.
Polylactic Acid (PLA) can be made into films, co-extruded into laminates, thermoformed and injection stretch blow molded into bottles.
Pd-BnM additions were made to the bottles by the injection of a known concentration of a stock Pd-BnM suspension, using a syringe flushed with N2.
Innovations: The CCV's body structure, assembled from four large pieces of a proprietary polyester-based injection-moulded resin (think plastic soda bottle), tipped the scales at only 210lbs.
The mixture was placed into a glass bottle fitted with a silicone rubber injection cap and this bottle was placed in a water jacket connected to a circulating water bath maintained at 35°C with rapid mixing until diethyl ether removed.
Polyethylene terephthalate (PET) bottles, which are usually produced by injection stretch blow moulding (ISBM) are widely used for carbonated soft drinks (CSD) storage and transportation.
