Sentence examples for injected consecutively from inspiring English sources

In a typical experiment, 25 aliquots (5 µL each) of 5 mM bisANS were injected consecutively from the syringe into the calorimeter cell containing 25 µM PDC-109.

These three compounds were injected consecutively with a specific time gap and ECAR values were measured after each injection.

Each prepared solution/aliquot was injected 8 10 times consecutively on the same day to study intra-day precision.

Three prepared aliquots at three different concentration levels (approximately 0.15, 0.3200 and 0.5186 mg/mL morphine) were injected ten times consecutively on the same day to study intra-day precision.

The selenium precursor solutions were consecutively injected with an interval of 15 min into the Cd/OA/ODE solution at 230 °C under inert atmosphere.

Six technical replicates were consecutively injected in a TripleTOF 5600 MS. The Venn diagrams indicate the number of peptides identified in each analysis and the number of peptides shared between the runs.

HLA class I peptides were freshly isolated from JY cells and six technical replicates were consecutively injected in a TripleTOF 5600 – three datasets were acquired in DDA mode and three datasets were acquired in SWATH/DIA mode.

The conscious animals were gently restrained by hand, the injection needle was inserted through the guide cannula, and vehicle (5 μl 0.15 M saline) or NPY receptor antagonists BIBP-3226 2000 nmol/5 μl; BIIE-0246 120 nmol/5 μl) and ghrelin (0.03 nmol, 0.3 nmol or 3 nmol/5 μl), were consecutively injected ICV slowly over a 60 s period.

Eight were injected intraperitoneally daily for 8 days consecutively, with either DBZ (5 μmol/kg dissolved in DMSO) and nine with DMSO (control mice).

For induction in adult mice, Tam was injected intraperitoneally at the same concentration, into 4 weeks old mice once a day for 5 consecutively days.

The power injection curtailment is applied consecutively to the three inverters, which means if the reduction to zero of the active power injected into the grid by inverter #1 would not be sufficient to maintain the grid voltage below the disconnection threshold, the inverter #2 would start to reduce its active power to provide its contribution to grid voltage reduction.