Sentence examples for initial specimen from inspiring English sources

But other tests on similar specimens did not, prompting some virologists to question whether the initial specimen was contaminated at a lab where earlier tests for SARS had been conducted.

Pole figure analysis indicates that compared with the initial specimen, textures below 930 °C are weaker, while at 930 °C they are stronger.

Optimized local lamella orientations and ceramic contents are calculated, and the difference between the initial (specimen with constant ceramic content and orientation) and the optimized designs is analyzed.

It was found that the reduction of surface roughness (RSR) after vibration-assisted forming was affected by static stress, vibration amplitude, material properties and initial specimen surface roughness.

The initial specimen, with a diameter of 13 mm, continuously passes through the rolls, equal channel angular pressing (ECAP) dies, and wire-drawing dies in sequence during the process.

The present location of this initial specimen is uncertain; reportedly stored at the Hudson Bay Museum, it could not be located in 1915.

Through a comparison between strengthened and respective monolithic and initial specimens, the efficiency of the strengthening technique is evaluated.

In this study, 430 and 409L stainless steels having columnar and equiaxed structures were chosen as initial specimens to elucidate the role of microstructure and composition on ridging.

Thermal properties of the initial specimens and of the welds have been explored by means of differential scanning calorimetry (DSC) on DSC Q2000 device from TA Instruments (New Castle, DE, USA), in the inert atmosphere (higher-purity nitrogen, GOST 9293 74) under temperatures from 40 to 200°C with linear heating rate 20°C/min.

Thermal stability and thermal-oxidative breakdown (TGA) of the initial specimens and of the weld have been studied with TGA Q50 device by TA Instruments (New Castle, DE, USA), in the dried air atmosphere under temperatures from 30 to 700°C with a linear heating rate of 20°C/min.

Thermomechanical behavior and deformational characteristics (TMA) of the initial specimens and of the weld have been investigated with TMA Q400 EM device by TA Instruments (New Castle, DE, USA), in the dried air atmosphere, with a linear heating rate of 10°C/min under temperatures from 30 to 250°C.