Sentence examples for initial measurement for from inspiring English sources

To measure blood pressure (BP), subjects were first made to rest for 15 min, and then a qualified physician measured BP twice, during physical examinations in a seated position after one initial measurement for determining the peak inflation level using a standard mercury sphygmomanometer.

After the initial measurement, for every target, we first establish the search space based on the corresponding measured target similar to 2D configuration.

This anaerobic catechol solution at high pH was then transferred to a quartz cuvette and which remained capped for the initial measurement: for subsequent readings the cap was removed to allow air to interact with the solution.

After the initial measurement, for every target, we first establish the search space based on the corresponding measured target; then, we optimize the measured target by our proposed ELPSO algorithm to achieve the optimal localization, which is represented by the red pentagonal stars.

The rate of ethanol loss through evaporation was estimated, based on initial measurements for 1 l cultures at 30°C, 15 vvm aeration and 800 rpm agitation and assuming that the evaporation rate would be constant in chemostat cultures under these conditions.

When taking initial measurements for your cape, you want to add several extra inches for a hem.

The published instruments demonstrate strong reliability and validity, therefore they were the first choice for initial measurement of this uncharted population.

Standard assay with 3 mM ABTS was used for initial measurement of laccase activities by recording the increase of absorption with time at 418 nm (ϵABTS+ = 36,000 M-1 cm-1).

For the initial measurement of possible chemosignal transfer by handshake we measured three handshakes, one on each of three consecutive days, by each of the 10 participants (i.e., total 30 handshakes).

Table S2: Dilution of serum and urine samples for the initial measurement of CHI3L1 by ELISA.

Data for an initial measurement of relaxation time (T1) and equilibrium magnetization (M0) were generated using a series of saturation time delays from 120 ms to 10 s, covering the same slices as imaged during the bolus passage.