The vertical axis in Figures 2a and 3a denotes the word accuracy rate, and the other two axes indicate the initial and final spectral points, k L and k H, of the assigned sub-band, respectively.
where E 0 and E F are the initial and final energies of Ti, respectively, k B is the Boltzmann constant, T G is the temperature of the sputtering gas, N is the collision number, and E 1/E 2 is the ratio of energy before and after a collision.
The reagent relative velocity vector k is chosen to be parallel to the z axis, and the scattering plane contains the initial and final velocity vectors (noted as k and k', respectively).
Overall, the TANTAN submodel for a single tandem repeat of unknown length up to K consists of states R1, …, R K connected to initial and final states, as shown in Figure 3.
When the initial isotope enrichment of the body water (H d or O d, ppm) was calculated by the intercept method, we used the following equation (Król and Speakman, 1999): where O init and H init are the initial isotope enrichments of body water pool (H or O, ppm); k d and k o are the isotope turnover rate between the initial and final samples (h−1, see below).
Figure 2 Variations in contact angle with time at the constant wetting temperature of 600 K ( upper ) and variations in the initial and final contact angles with the substrate annealing temperature ( lower ).
λ is the solvent reorganization energy for the PT process: 9.9where Q̅ k A and Q̅ k B are the equilibrium generalized coordinates of the solvent for the initial and final states.
The initial and final weight and length were recorded and were used to calculate condition factor (K, 100 * BW/FL-3) where BW is body weight in g and FL is fork length in mm.
Still, because most research questions cannot be implemented using only simple set operations on k-mer lists, we expect that both the initial and final steps of analysis will be performed using custom task-specific tools.
