Sentence examples for ingress phase from inspiring English sources

Coronal radio sounding experiments with spacecraft near solar conjunction show a steady tendency toward enhanced radio frequency fluctuations during the ingress phase with respect to the egress phase.

The minimum exergy efficiency is 58.24% for the combustion chamber at the end of the ingress flight phase, while the maximum exergy efficiency is found to be 99.09% for the high pressure turbine at the start of the ingress flight phase and landing loiter.

Contacts I and II define the phase called ingress while contacts III and IV are known as egress.

In order to demonstrate the adequacy of the International Thermonuclear Experimental Reactor design from a safety stand point as well as investigating the behavior of two-phase flow phenomena during an ingress of coolant event, an integrated ICE test facility was constructed in Japan.

Stresses exerted due to local molar volume change across the electrode during hydrogen ingress into and egress from a single α-Pd phase are always exceeded by those stresses exerted across the electrode during hydrogen ingress into and egress from a mixture of α-Pd and β-Pd phases.

Any excess aluminium released by the slag was bound to a calcium deficient C-A-S-H phase and hydrotalcite, sheltering the aluminates from ingressing sulfates.

In order to identify crystalline phases and morphological and structural characteristics, nanographs were obtained by transmission electron microscopy (TEM), and phase change due to carbonation and chloride ion ingress were studied along with X-ray diffraction analysis (XRD).

Because the ectopic small micromeres ingressed at the time of skeletogenic cell ingression, we wondered whether isolated small micromeres could ingress on their own.

Separation of the articulating surfaces is most likely to occur during the swing phase of the walking cycle, or at any non-load bearing position, allowing ingress of the bursal fluid and its contents.

Fatty acids are increasingly being evaluated as phase change materials to enhance thermal regulation in buildings and as hydrophobic admixtures to reduce water ingress into concrete.

The ingress of sulfur or oxygen through the previously formed reaction products was found to produce internal corrosion phases within the alloy.