Sentence examples for infusion pressure from inspiring English sources

During infusion, pressure was transmitted from the pump to a glass, gastight, infusate-filled Hamilton syringe (250 microliter total volume) that was connected to PE50 thick walled polyethylene tubing (outer diameter 0.050 in, inner diameter 0.023 in) (Plastics One, Roanoke, VA).

In this study using a protocol designed to eliminate the influences of infusion pressure and shear stress, we evaluated the effect of CsA on vasorelaxation of coronary and pulmonary arteries after 16-hour University of Wisconsin (UW) solution preservation.

Processing conditions and material parameters such as permeability of fibers and foam; viscosity and cure kinetics of the resin; and resin infusion pressure and temperature all affect the cure.

In addition due to the increased risk of neuropathy as a result of increased volume effect caused by dura mater adhesions and influx of blood into the subarachnoid space under excessive infusion pressure, we judged that infusion into the dorsal epidural space should be avoided [13 17].

Due to the small gap size between the device and cells, the deflection of the PDMS membrane due to gas infusion pressure needed to be assessed.

Due to the small gap size between the device and cells, the deflection of the PDMS membrane due to gas infusion pressure needed to be assessed, as shown in figure 2. The device was laid on its side and deflection distance was measured using microscopy.

The use of 40 mm Hg arthroscopic infusion pressures will assist in reducing postoperative pain.

Arthroscopic infusion pressures were kept the same throughout the entirety of each patient's procedure.

Qualitatively we observed that the use of lower fluid infusion pressures did not compromise surgical view quality and access.

Duration of arthroscopic infusion was strongly correlated with total infusion volumes (R 0.91 0.97 at p < 0.0001 for 40 and 80 mm Hg infusion pressures respectively, Fig.  1).

Thirty six patients were also prospectively examined to determine arthroscopic fluid infusion rates for 40 and 80 mm Hg infusion pressures.