Sentence examples for inferred strength from inspiring English sources

Then, if a crater can be measured with an accuracy of δR, the inferred strength from Eq. 2 can be measured to an accuracy δσc/σc = 4δR/R.

Similarly, if the crater excavation time can be estimated to an accuracy of δT, the inferred strength from Eq. 3 can be measured to an accuracy δσc/σc ∼ 0.75δT/T.

The discrepancies in the inferred strength of conservation between scenarios with different selection orientation but same selection strength do not vanish at this higher selection coefficient.

Finally, selection gradients acting on body mass are all negative, and positive in tibia length (Additional file 3: Table S3), with the average inferred strength of directional selection on tibia length being over two times greater, in absolute terms, than for body mass.

As we note later, however, this is within a factor of a few of inferred global strength, indicating that a more detailed analysis of the fission conditions of rubble pile bodies should be performed, improving the approximate model given in Eq. 1.

The inferred control strength matrix A is listed in Table 2 and Additional File 1: Table S4.

The inferred control strength matrices for various gene expression data are listed in Table 4. Ndd1 regulated on CHS2 is the highest positive regulation for α-factor as observed from Table 2.

The inferred control strength matrices for gene expression data are listed in Table 4, and the regulated actions for seven TFs (Abf1, Fkh1, Fkh2, Mcm1, Ndd1, Phd1 and Ste12) are shown in Figure S2.

The correlation between the externally measured (inferred) strength-strain data and the actual material dynamic response within the specimen is examined.

That's a poor assumption that can alter the inferred interaction strengths, he says.

Thus our inferred minimum tensile strength of the 5 μm chondritic porous IDPs of ~ 150 to 325 N/m2 is comparable to the strength inferred for some of the weak cometary meteors and the nucleus of Comet Shoemaker-Levy 9, and a factor of 3 to 6 higher than the ~50 N/m2 of the uncompacted, bare silicate studied by Blum et al. (2006).