B. megaterium 1295S has produced cellulase on CYE2 twofold than on CYE1 and indicating the ability to produce cellulase genetically.
Mice receiving OVA alone produced only IgG1 Abs, indicating the ability of EP67 to induce a Th1-like Ab class switch.
The ECFP4 ROC curve is shown in Figure 4, where it will be seen that a very high AUC value (0.988) is obtained, indicating the ability of this fingerprint to discriminate between similar and non-similar molecule-pairs.
Strain 3589 could grow up to 100 g L -1 WCO and accumulate 0.43 g g-1 lipid indicating the ability of the strain to tolerate toxic compounds and accumulate lipids at high WCO concentrations.
In the presence of conjugated PlnD1, the rhBMP-2 loading efficiency was approximately four-fold higher, indicating the ability of PlnD1 to significantly enhance the loading capacity of electrospun PCL scaffolds.
GnP suspension was confirmed via UV-vis spectral data while contact angle measurement elucidated the close resemblance to an aqueous solution indicating the ability of GO to mediate the flocculation prone GnP colloids.
Virtually all previously performed studies on the diagnostic accuracy of coronary CTA have shown a high sensitivity and high negative predictive value indicating the ability of this noninvasive method to exclude relevant morphological coronary artery disease [1, 2, 3].
The activated regions were consistent with previous studies, indicating the ability of the proposed approach in detecting brain activation without a priori assumptions about the shape parameters of the HRF.
This heat-triggered material phase transition of the composite was found to follow exposure of NIR light, indicating the ability of the NIR absorption by the nanoshells to sufficiently drive this transition.
It could be observed that the microbial population changed while passing the treatment system, indicating the ability of biological waste gas treatment systems to retain potentially pathogenic microorganisms from waste gases.
Significant differences in the evolution of a change of a shear wave reflection coefficient Δr in time were observed, indicating the ability of the method to monitor setting process of cement pastes.
