Sentence examples for index meter from inspiring English sources

The paper describes the definition of ΔV10 index and proposes a block diagram for the index meter, based on the structure of a flickermeter.

Flame retardancy were carried out by a JF-3 oxygen index meter and a FTT Cone calorimeter, respectively.

A JF-3 oxygen index meter was employed to measure the LOI values of the specimens with dimensions of 100 × 6.5 × 3 mm3.

Moreover, the incorporation of 5 wt.% ZHS/GO imparted excellent flame retardancy to flexible PVC, as shown by increased limiting oxygen index, reduced peak heat release rate, and total heat release tested by an oxygen index meter and a cone calorimeter, respectively.

The consumer data includes consumer index number, meter number, meter installation date, consumer address and meter reading with date.

In terms of flow, when the water content is 100%, the productivity index per meter is 30 m3/d × m × MPa, compared to the productivity index per meter when water content is 30 and 10%, the difference between the two values is very large.

J = frac{Q}{{(p_{text{e}} - {p_{text{wf}}})h}} (1) where: J fluid productivity index per meter (FPIPM), m3/(m × d × MPa); q flow rate, m3/d; h effective overflow length of the screen, m; Pe reservoir pressure, MPa; Pwf bottom hole gas flowing pressure, MPa.

At the same time, it also shows that the productivity index per meter of six groups experiment is relatively high in the early stage of simulation experiment, along with the experiment, the screen blocked fastest which only needs 7 min when the water content is 30 and 10%, and the productivity index per meter is the lowest.

The proposed definitions add information to alleviate the power and energy measurement problem of the power meters, offer alternative indexes to measure the energy distribution, and allow calculations in transient and steady states.

Open image in new window Fig. 4 Curves of productivity index per meter under different water content Open image in new window Fig. 5 Comparison chart of productivity index per meter under different water content. 1 From the test of the swelling of montmorillonite with different moisture content, we found 1.

The production can be defined by the productivity index per meter (Deng et al. 2011), as shown in formula (3).