Sentence examples for increment of voltage from inspiring English sources

The results are compared in terms of increment of voltage estimation accuracy when considering hysteresis and influence of hysteresis on a certain technology.

Low (2 V) and moderate (4 V) voltage electric fields provoked the growth of the species while high voltage (10 V) had an opposite effect and metal concentrations of the plants elevated with the increment of voltage.

It is possible to suggest in this scenario that alkali treatment plays an important role the shell layer of PEDOT PSS could passivate the dangling bonds of SiNWs surface and thus reducing the effects of charges recombination by suppressing the effects of interfaces states, which results in the higher charge storage per unit increment of voltage [29].

The C p enhancement shows that the interface capacitance between alkali-treated SiNWs and PEDOT PSS is more perfect electrically than that of the device without alkali treatment; this is consistent to the reduced J 0. The higher capacitance value may be attributed to the well-organized PEDOT PSS/SiNW morphology facilitating the higher charge storage per unit increment of voltage.

To investigate the influence of possible (low frequency) charging effects at the electrical contacts and leads, current voltage (I V) curves were recorded in both increasing and decreasing increments of voltage.

The absolute value of the increment of the voltage bias was 20 mV in all measurements.

These effects resulted in the increment of breakdown voltage for the trenched LDMOS more than 100 V compared with the conventional device.

Specifically, (3) indicates the increment of phase A voltage, while (4) indicates the decrement of phase A voltage from the rated voltage.

It should be noted that the influence of quantum confinement depends on the increment of gate-source voltage.

Leakage current, on off current ratio and subthreshold swing improve with an increase of the length and concentration of the HD region, due to the increment of the threshold voltage and the barrier height of the p n junction near the source.

Finally, all sensors were interrogated using squarewave voltammetry with a frequency of 60 Hz, a pulse amplitude of 25 mV, and a voltage increment of 1 mV.