Sentence examples for increment of pressure from inspiring English sources

With the reduction of adsorbent selectivity and the increment of pressure ratio, the hydrogen recovery ratio will increase and the total annual cost will be reduced.

The results showed that porosity increased with increment of pressure and decreased with increasing the ratio of the high molecular weight PCL to the low molecular weight PCL in the scaffolds and also HA content.

For the GO-SH film on DA subphase without UV light irradiation, the obtained curve demonstrate increment of pressure at the beginning of compression and long platform region after 11 mN/m, suggesting possible conformation change of building block GO-SH due to the adsorption process with DA molecules in subphase solution.

Then, as shown in Fig. 2b, it can be easily observed that the isotherm of GO-SH spread on pure water surface show slow increment of pressure at trough area of 77 cm2 until reaching 18 mN/m at compression end of trough area 23 cm23

Comparing with normal hip, hip of DDH has a 26% reduction of the contact area and a 23% increment of pressure [ 27].

This result can be intuitively explained by the fact that, once the correct methodology is applied, it is an increment of pressure, not its absolute value, that causes an additional passive inflation of the tissue, and it is the ratio between these two increments that determines the stiffness of the material and the decay of active tension.

It was found that the increment of critical pressure led to a decrease in cycle operating pressure ratio which resulted in a negative effect on total cycle efficiency.

At the pressure of 0.5 2.0 MPa and 800 °C, tar had the similar molecular weight distribution and the average molecular weight, the UV spectra absorbed at 254 nm revealed tar of sawdust air gasification at different pressures had aromatic character which increased with the increment of the pressure.

The electrical resistance decreases with the increment of compacting pressure exponentially.

All three reactions consume CaO and evolve H2O, strongly suggesting an association between the increment of fluid pressure with the progress of the reactions.

In addition, with the increment of surface pressure of 15 mN/m, closely packed self-assembled films with obviously increased thickness can be formed, as shown in Fig. 3d f.