Sentence examples for increasing solidification rate from inspiring English sources

The bubble is entrapped earlier by increasing solidification rate.

With increasing the solidification rate from 0.4 to 1.2 °C/s remained γ/γ′ eutectic size was reduced about 85% in CM247 LC and 60% in Ta-modified CM247 LC after solutioning treatment.

Increasing the solidification rate results only at mould thicknesses of 4 mm and below in a significant refinement of the particle microstructure, necessitating liquid metal deposition techniques to utilise it for obtained improved mechanical performance of HMS.

The results show that an increase in solidification rate in Case 1 decreases and increases pore radius in the early and late stage, respectively.

However, the experimental results reported by Fan and Khodadadi [5] reveal that the increase in solidification rate is considerable only when the volume fraction of copper oxide particles is 0.5 and further increase in fraction could not accelerate the solidification linearly.

The lamellar spacing was found to increase with decreasing solidification rate, in agreement with the Jackson–Hunt theory.

The solidification rate increased, as the mass flow rate increased, therefore the mass flow rate at 37.4 kg/min consumed a short time, compared with the 16.2 and 29.4 kg/min.

For CADZ, casting at a high solidification rate allowed an increase in ductility to be obtained as a result of fine-grained structure and low internal stress.

Khodadadi and Hosseinizadeh [3] have shown that the solidification rate of pure PCM could be increased by adding copper nanoparticles.

It further describes solidification rate.

Microstructure shows dependence upon the solidification rate.