Sentence examples for increased in the direction of from inspiring English sources

But with increasing n ^ parameter, the difference between linear and nonlinear cases has increased in the direction of the desired response (x direction) and decreased in the perpendicular direction.

This indicates that the stiffness had still been selectively increased in the direction of the instability of the force field.

This indicates that the stiffness had still been selectively increased in the direction of the force field.

In order to confirm that the stiffness was still primarily increased in the direction of the instability of the environment, the ratio of the stiffness increases in the two stiffness terms were compared.

The denaturing gradient gel was formed with 8% polyacrylamide stock solution containing either low (40%) or high (70%) concentrations of urea and formamide that increased in the direction of electrophoresis.

Figure 8 depicts that an increase in Gr results in the mass flux to increase in the direction of the fluid flow and this may be attributed to the buoyancy force acting on the fluid.

These triangle plots show the top 1 candidates for all (omega _i) combinations, colour-coded (black 0 % of the correct candidates ranked first, yellow 10 0 % of the correct candidates ranked first) with the (omega _i) per category increasing in the direction of the arrow.

The brightness continues to increase in the direction of Jupiter and has a maximum near the ring's center at, although there is a pronounced gap (notch) near the Metidian orbit at.

Denaturing gels contained a 35 75% gradient of urea and formamide, increasing in the direction of electrophoresis.

The 8% polyacrylamide gels (ratio of acrylamide:bisacrylamide, 37.5 1) (Bio-Rad) contained a 30 to 55% gradient of urea and formamide (Fluka, Sigma-Aldrich, St . Louis MO, USA) increasing in the direction of electrophoresis, which was run at 130 V and 60°C for 4 h.

It was found that Young's modulus increased in the longitudinal direction of the coils both in the vibrating and tensile measurements, which resulted from the decline of graphitization during the growth of the CNCs.