Sentence examples for increase on the structure from inspiring English sources

The strength of any edge is measured as the increase on the structure score that the edge provokes when it is added to the structure.

Another challenge with the main armament was that its weight, which had to be spread over much of the hull, led to increased stress on the structure.

The effect of an increase in pH on the structure of polyaniline absorption spectra manifests itself in the increase of the portions of the bands corresponding to different electron transitions in the quinoid fragments, as well as in the decrease of the portions of the bands related to the conductivity of the film (i.e. the bands of the cation-radical dimers (or polarons) and free charge carriers).

The results indicate that except the measurement points at structural supports, the CPST values at all the measurement points on the structure increase with structural damage level irrespective of the damage location, indicating that using a single or a minimum number of measurement points and their CPST value can effectively identify damage existence in the structure.

The risk factor of such structure may increase, if the structure rests on sloping ground.

With the need for higher temperatures, larger apertures of the troughs are required to increase the concentration ratio, however, this also increases the wind loads on the structure.

The effects of increasing levels of local extinction (by increasing the jet velocities) on the structure and statistics of the mixture fraction fluctuation and scalar dissipation rate fields are investigated in detail.

The increase of the load on the structure appears as a result of the big ice-structure contact area and additional adhesion forces.

Failure of the building envelope allows wind and water intrusion into the building, and pressurization or depressurization of the interior of a structure may significantly increase differential pressure loads on the structure itself.

Damping ratio considerably increases with installing TLCD on the structure.

Above a pH of ca. 11, the stripping peak appears to stay constant or increase, depending on the surface structure.