Sentence examples for increase of interface from inspiring English sources

Among the most significant variations, a general increase of interface apolarity and packing density in hyperthermophilic enzymes were found.

The results show that the contact conductance increases with the decrease of surface roughness, the increase of interface temperature and contact pressure.

The formation of vacancy defects and increase of interface roughness in crystalline process is considered as the reason for the reduction of luminescence.

On the other hand, the flexural strength and flexural stiffness of concrete-filled stainless steel SHS and RHS tubes were increased with the increase of interface friction coefficient between stainless steel tube and concrete up to 0.6.

Also, it was suggested from microscopic fractographic analysis that the improvement of thermal shock resistance of MgO-C refractories was positively correlated with the increase of interface crack propagation.

It is found that the degradation of NON barrier is associated with the increase of interface state density at the tunneling barrier/silicon channel by programming and erasing (P/E) stress.

The high crystal quality and thermionic effects in heterostructures may contribute to the larger Seebeck coefficients, while the increasing of interface scattering for electrons probably is the reason for large electrical resistivities.

Obviously, as the concentration of CIGS NCs increases, the Jsc linearly increases due to the increasing of interfaces between P3HT and CIGS NCs, whereas the Voc decreases due to the decreasing of the shunt resistance.

Without Au nanoparticles, the current-voltage characteristics demonstrate the large values of the non-ideality factor and saturation current due to the thick intermediate oxide layer, increased density of surface states, and increased area of interface.

Assigning charge transfer resistance to the resistance of the electrode|film interface, its observed decrease with subsequent saturation is explained in terms of an increase of the interface area until the entire electrode is covered with the inorganic film completely.

HRTEM confirmed both the increase of the interface roughness with increasing carbon ion energy and the changes in the correlation of the interface corrugations observed by SAXS.