Sentence examples for inadequate adhesion from inspiring English sources

It was also found that inadequate adhesion to the soft substrates due to the generation of high residual stress in the film as it grows on the surfaces.

Subsequent stress analysis showed that the epoxy undercoat substantially raised the residual stress in the zirconium and that the inadequate adhesion in the prototype machine was due to its rapid deposition rate.

The development of new biodegradable polymeric tissue adhesives has been almost stagnant for the past 10 years, primarily due to the inability to overcome the problem of inadequate adhesion properties.

The behavior of mifepristone-treated cells supports the data of Born et al. [ 33], suggesting that high ruffling rates are indicative of inadequate adhesion, whereas low ruffling rates are associated with optimal adhesion.

Poor adhesion could be improved and optimized by adhesion promoters.

Some of these methods have severe limitations such as poor adhesion, microcrack formation and phase changes at high temperature, non-uniformity, and improper microstructural control, all of which make them inadequate for implant systems [14,15].

Surgical activities that may induce adhesion formation (i.e. non-closure of peritoneum, inadequate haemostasis, applied sutures, use of adhesion barriers).

Strategic conversion (e.g. due to inadequate visibility, adhesions or additional pathology) was distinguished from reactive conversion (i.e. because of a complication) [ 33].

However, these devices do not realistically mimic the in vivo geometrical features (e.g., successive bifurcations, vascular morphology) and flow conditions (e.g., converging or diverging flows at bifurcations) and are inadequate for studying adhesion event differences between healthy and diseased vasculature.

It was also confirmed to inhibit anoikis (apoptotic response induced in normal cells by inadequate or inappropriate adhesion to substrate) in the in vitro model of carcinoma of colon [ 11] and specific silencing of this gene led to decreased metastatic potential in pancreatic adenocarcinoma [ 12].

During the insertion process the adhesive fills a very narrow gap over significant anchorage contact area, raising concerns that manufacturing defects may impact the structural performance of the bonded joint, namely the possible lack of adhesion resulting from inadequate preparation of the joint on site.