Sentence examples for inaccessible pore from inspiring English sources

Inaccessible pore volume.

It was shown that by increasing the salinity of polymer solution, some properties such as polymer viscosity, inaccessible pore volume and permeability reduction factor are reduced.

However, with an increase in the polymer concentration, the inaccessible pore volume increased and the polymer could not enter into small pores.

Permeability reduction, adsorption reversibility, inaccessible pore volume and selection of a correlation curve for the function of viscosity vs. concentration can influence NPV by less than 3%.

However, after the polymer concentration exceeded a limit, the inaccessible pore volume would increase and the incremental oil recovery owing to additional increase in the polymer concentration would be insignificant (Guo et al. 2014).

In this paper, we present the numerical modeling of polymer retention and the reversibility, inaccessible pore volume, shape of the curve of viscosity vs. polymer concentration, salinity, permeability reduction, non-Newtonian behavior and degradation, etc.

This has been attributed to the initial loss of the most inaccessible pores within the network.

An efficient numerical method for the detection of the inaccessible pores is introduced for models in the kinetic limit, where the front speed is constant.

The 3D method keeps all the virtue of the 2D model: robust numerical capturing of topological changes of the interface such as the merging, and fast detection of the inaccessible pores.

Here we demonstrate that SANS and USANS can be also used for determining the fraction of the pore volume that is actually accessible to fluids as a function of pore sizes and study the fraction of inaccessible pores as a function of pore size in three coals from the Illinois Basin (USA) and Bowen Basin (Australia).

This work systematically derives an axial temperature profile inside the inaccessible membrane pores by combining a one-dimensional reactor model of mass and energy balances with experimental measurements of reactor temperatures and conversion, applying ethene hydrogenation as a model reaction.