Sentence examples for in the experimental device from inspiring English sources
Both approaches can explain and predict the degree of coalescence observed in the experimental device.
Specifically, two different variations of the Compliance Control have been adapted for their application in the experimental device powered by pneumatic muscles.
It is hypothesized that the large space in the experimental device designed to accommodate test samples up to small animals acts as an effective heat sink preventing temperature increases above 43°C.
Due to the high sensitivity to geometric imperfections of these structures, a simple procedure to obtain their measurements once the specimen is placed in the experimental device is set out.
In order to determine whether the laser increase the temperature in the experimental device, we determined this parameter in the water drop on the functionalized glass surface (with or without AuNPs) observing increments of about 4 °C after irradiation (Additional file 1: Figure S5).
The global heat transfer coefficient (Hgl) under vacuum at low contact pressures (0.5 1.5 MPa) between CC and CuCrZr heat sink substrata has been measured in the experimental device, installation of contact heat transfer measurements (ITTAC), using different compliant materials.
In the paper, the experimental device is described and first results are presented.
The device structure in our simulation is the same as the experimental device reported in Ref. [7].
The forceps was attached to the experimental device, in which three disks were rotated using the motor.
In the comminuted fracture trials the experimental device exhibited significantly greater stiffness (P =.048), ultimate load (P <.001) and energy absorbed (P =.048) before failure, and significantly less displacement at higher (P =.004) and lower physiologic loads (P =.011).
In the noncomminuted fracture trials the experimental device exhibited significantly greater stiffness (P <.001; P =.002 for normalized values) and ultimate load before failure (P =.015) and significantly less displacement at higher physiologic loads (P =.031).
