Your English writing platform
Discover LudwigExact(3)
They investigated combination of 10%% SF, 25%% slag, 15 % FA and 50%% cement, and found an increase in strength about 22%% over the control mixture (with neat cement) at age of 14 days.
A design recommendation including one fatigue class increase in strength (about 12.5%) for every 200 MPa increase in static yield strength is proposed and are shown to be conservative with respect to all available data.
In a comparison with the reference lime plaster without any additives, the experimental results show three- to five-fold increase in strength, about 25% decrease of water vapor diffusion coefficient, 20% decrease of water absorption coefficient and a very high increase of freeze/thaw resistance.
Similar(57)
This was the first time the gain in strength brought about by the use of sand drains had been quantified.
There were nine divisions in the ARVN — varying in strength from about eighty-five hundred ten thousandand men — and three of them were in Porter's corps region.
Maximum loss in strength was about 65% at full replacement.
However, SCCs with both fine and coarse RAs (RCAs + RFAs) had relatively worse performance than those with only RCAs or RFAs such that the reduction in strength was about 30% as compared to the corresponding reference mixes.
Patient 1's increase in strength was about 10% during the first infusion, suggesting a transient effect of the therapy in the recovery of strength, probably favored by the deletion of B cells.
The light should increase in strength over about half an hour before you wake up.
The enhancement in Young's modulus can reach up to 2.5 times higher than that of neat epoxy whereas the enhancement in tensile strength is about 1.5 times in functionalized DND/epoxy nanocomposites.
% of short glass fiber reinforced PA66/PP polymer blend, there is an increase in tensile strength of about 44% and an improvement of flexural strength of about 33% more than that of the neat blend was observed.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com