Sentence examples for in satisfactory function from inspiring English sources

β2MG concentration was significantly higher (P = 0.011) in the subset of patients with allograft dysfunction: 8.67 ± 2.48  μg/mL versus 6.67 ± 2.13  μg/mL in Satisfactory Function subset.

Fifteen percent of patients from the Dysfunction group showed the increase in eGFR by ≥25% after 1 year, whereas such patients were absent in the Satisfactory Function group (P < 0.001).

Despite the satisfactory function in daily activities, the measured function of the left wrist was impaired compared to the right (Table 1).

Previous literature on the biaxial wrist prosthesis showed satisfactory pain relief, an improvement in range of motion, and satisfactory function after follow-up of 6, 3, and 4 years but also loosening, infections, and dislocation (Cobb and Beckenbaugh 1996, Courtman et al. 1999, Takwale et al. 2002).

Optimal outcome was achieved in recipients of control kidneys and KNW with prompt function and satisfactory function based upon serum creatinine in the first 6 months and in recipients with lower rates of rejection.

The incidence of rejection was significantly lower in control kidneys and KNW with satisfactory function versus control kidneys and KNW with unsatisfactory function.These data demonstrate: (1) similar graft survival at 12 months, (2) lower donor age, (3) higher minimum 4-hr urine output, and (4) more HLA matches in recipients of control kidneys versus KNW.

Time after transplantation exceeded 10 years in 35% of patients from the Dysfunction group and in 15.4% of patients with satisfactory function (P = 0.045).

At the same time, the eGFR increased by ≥1 m/year/1.73 m/year in 30% of patients from the Dysfunction group and in 31% of patients with satisfactory function (P > 0.05).

Reconstructing a penile stump secondary to trauma or cancer should result in satisfactory penile function and appearance.

22.5% of patients from the Dysfunction group and 13% of patients from the Satisfactory Function group displayed the decrease in eGFR by ≥25% compared to baseline (P = 0.260).

Surface roughness is an important factor in determining the satisfactory functioning of the machined components.