At x = 0, sequence hits with an E-value of 0 were removed in order to avoid annotation transfer from exactly matched sequences.
In order to avoid any approximation in removing the effect of soil nonlinear response, we use a simple model, a single horizontal soil layer over a bedrock, modelled as elastic.
Additionally, in order to avoid scale indeterminacy and remove constant values, we have to work with normalized sources S i, i.e. S i ← ( S i − μ i ) / σ i 2 where μ i and σ i are the mean and standard deviation associated to source i.
From here, four were excluded with the main reasons being lack of data on the exposure (mode of delivery) or the outcome of interest (sub-fertility defined as time to next pregnancy/birth) and one study [ 31] used the same data source as another eligible study [ 16] and so in order to avoid duplication of data was removed.
In order to avoid estimating noise power, one can remove all the zero-lag entities.
The ball lens covering the detector has been removed, in order to avoid any effects on the transmission.
For the unpruned logs, the re-grading scenario simulated a "brashing" regime in which any dead or dying branches in the lower crown were removed in order to avoid development of dead, bark-encased and rotten knots.
As the goal of this research is to study human settlements, they should be removed in order to avoid their misinterpretation as small cities.
After conversion of all sources to SMILES, stereochemical information was removed in order to avoid differences between representational conventions and thereby allow a direct all-against-all database comparison [26].
Note that here, it should be pointed out that the remaining resist film after α-Si mask patterning is very necessarily removed in order to avoid a not good influence on the fabrication of SiO2 nanotrench arrays.
Thus, if pressure readings are outside this range, they can be easily detected and removed in order to avoid that they degrade the accuracy of the UT1-UTC estimates.
