Sentence examples for in line profiles from inspiring English sources

Images in the center (a a,b a,c a, and d a ) show the 2D AFM images, while images of the right are in line profiles (a b,b b,c b, and d b ) of the corresponding samples to the 2D AFM images of the center.

In line profiles, across the two facets (as is normally observed in HRTEM), they appear quite similar in roughness at this stage, but from the STM top view, we can see that the {111}B-type facets have steps toward the interfaces of the adjacent {110}-type facets in two ⟨112⟩B-type directions; thus, in fact, the {111}B-type is more rough already at this stage.

A combination of sampling by broadside fan-recordings and in-line profiling allows us to image increases in Moho depth towards the centre of the plateau.

The x-axis in line-profiles represents the length and y-axis corresponds to the height along the line-profilers, which are indicated as white lines in the 2D AFM images.

The quality of the inpainting can also be appreciated qualitatively in the insets in Figure 2c,f, and in the line profiles in Figure 2d,g, where a good match between the ground-truth image (full black line) and the recovered image (dashed red line) is observed.

At the same time, the diffusing atoms were accumulated around the void edges, making large bumps and trough on the surface as depicted in the line profiles in Fig. 1f-2.

The same trend of improved recovery and image contrast with increasing number of iterations, even up to 100 iterations, can be seen in the line profiles in Figs. 8 and 9, where the central values approach activity concentrations close to the true activity concentration in the myocardium.

When there was a peak in relative line profiles for one combination of two flats, the corresponding peak could appear in all absolute line profiles of A, B, and C flats in the three-flat method.

Some high peaks are visible in the line profiles which correspond to the white particles and may be some dirt particles (as the measurements were done at ambient conditions).

The change of surface morphology is also clearly depicted in cross-sectional line profiles in Fig. 9 a-1), (d-1).

As sharply compared in the cross-sectional line profiles in Fig. 2 a-1), (d-1), the height of resulting nanostructures were radically increased with the increased DAs from 2 to 6 nm.