Sentence examples for in double mode from inspiring English sources

In Figures 1(a) and 1(b) it is shown that human astrocytes obtained from adults also respond in double mode to BPA.

In case of double mode excitation, the particle concentrations increase a factor 4 to 18 times for 200 nm to 800 nm particles respectively.

Threshold number enables the images to switch from grayscale to double mode in which each pixel of image can only be colored black or white.

Figure 5 depicts the failure shapes for all columns of group No. 2. Open image in new window Fig. 5 Final failure modes for all columns of group No. 2. For all columns bent in double curvature mode, failures were similar to the case of single curvature modes with unequal end eccentricities where all columns failed near the end support of the higher end eccentricity in flexural mode of failure.

The prototype can operate in either single-effect mode or in double-effect mode or can also operate simultaneously both modes using the components common to both modes, namely, the absorber, evaporator, condenser, solution pumps and control equipment.

Figures 6 and 7 show the failure shapes for all columns of groups No. 3 and No. 4. It can be noted that column bent in double curvature mode sustained higher load than the opponent column bent in single curvature mode.

Therefore, the greatest reduction in the ultimate load capacity will occur for the case of equal end eccentricities for columns bent in single curvature mode, while the smallest reduction will occur for the case of equal end eccentricities for columns bent in double curvature mode (MacGregor et al. 1970; Milner et al. 2001).

Collectors were also tested in double pass mode to investigate the extent of improvement in efficiency that could be achieved without increasing the collector size or cost.

The collectors are also studied in double pass mode to investigate the extent of improvement in efficiency that can be achieved without increasing the collector size or cost.

In the present paper, a magneto-optic element like Terbium Doped Glass (TDG) has been experimentally studied in double pass mode for its use as a displacement sensor.

It has been found that the roughness geometry used on each side of the plate in double pass mode enhances both frictional losses as well as heat dissipation rate.