The slight increase in CDD during the last 20 years suggested that cooling requirements and, hence, energy use for air conditioning might be affected if the trend persisted.
In CDD(2), density of screw dislocations can be approximated as ρ s ≈ρ11.
Over 700 molecules with target related information from the literature were curated for use in CDD and TB Mobile.
Unlike theories based on the Kröner-Nye tensor which measures the excess dislocation density, in CDD, dislocations of different orientation can coexist within an elementary volume.
An additional 60 molecules with target related information from the literature (Additional file 1: Table S1) were curated for use in CDD and TB Mobile.
The cross slip annihilation rate of the second order alignment tensors in CDD(2) can be calculated by plugging the corresponding DODF into (28).
The cross slip annihilation rate of DODF in CDD(1) can be calculated by plugging the DODF of CDD(1) given by (50) into (28).
Due to this fundamental difference, in CDD, dislocations interactions should be dealt with a different approach than in GND-based theories.
We finally demonstrated that by including annihilation and generation mechanism in CDD theory, even zeroth-order CDD theory (CDD 0)) obtained by truncating the evolution equations at scalar level, can describe the first 3 stages of work hardening.
In CDD [11] a single data stream is sent from all transmitter antennae with a different cyclic delay applied to each replica, effectively resulting as if the original stream was transmitted over a channel with increased frequency diversity.
Note that, in CDD and SDM, for low to moderate values (0.0-0.7 0.0-0.7lation at either end results in a similar BER degradation, however, for large values (>0.7), correlation at theithersmittendis significantly moresultsterinus than at the receiver.
