Endothelial dysfunction is an important defect that contributes to erectile dysfunction and vascular disease in diabetes and is associated with insulin resistance [18].
Elastic deformation is one of the most important atomic defects that takes place at low stress and has three main characteristics: (1) it is reversible, (2) stress and strain are linearly proportional to each other according to Hooke's law, and (3) it is usually small.
Below, the most important genetic defects that have been detected in NB are briefly discussed.
The most important coagulation defects that may remain undetected with routine coagulation tests are platelet dysfunction and hyper-fibrinolysis.
Follow-up is an important consideration for defects that may not be readily observed at birth, because if too short, then defects could be missed and an association becomes diluted or not detected.
Changes in cellular respiration and differences in the respiratory effects of inhibitors are important indicators of mitochondrial functional defects that result from damaged mitochondrial proteins or DNA (mtDNA), or substantial alterations to mitochondrial signaling cascades.
It seems more likely that single motif gM mutants have subtle defects that are important for evolutionary fitness, where a 10% difference in virus transmissibility would have a major impact, but hard to detect in experimental pathogenesis, where transmission is hard to reproduce and limits on animal numbers make replication reductions of <90% hard to demonstrate.
However, only a few genes have been validated in humans and it is important to identify new gene defects that could be responsible for autoimmunity.
As we mentioned in Figure 2b, there is a deviation between the oxygen impurities and the volume fraction of voids PV when RH is above 98.6%, which probably resulted from another important defect structure, that is, grain boundaries between the nanocrystallites and the amorphous matrix of the nc-Si H films.
Therefore, it is important to design a control chart for proportion of defects that takes production quantity requirements into account.
