Sentence examples for impactor series from inspiring English sources

PM from dairy farms were collected with a high-volume air sampler (model GS2310; Andersen Instruments Inc., Smyrna, GA) equipped with a four-stage cascade impactor (series 230, Andersen Instruments, Inc). in the summer months of the year 2008 from various dairy farms and an urban area (Fresno, CA) of the San Joaquin Valley in California.

Particulate matter used in this study was collected with a high-volume air sampler (model GS2310; Andersen Instruments Inc., Smyrna, GA) equipped with a four-stage cascade impactor (series 230, Andersen Instruments Inc). in the summer months from a location in the northeast of the San Joaquin Valley in California.

PM2.5 and PM10 were collected on prebaked (350 °C) quartz fiber filters (No.1851-865, TisClevesirOHmental, Cleves, OH) using a High Volume Cascade Impactor (Series 230, Tisch Environmental, Cleves, OH).

The system utilizes the principle of virtual impactors to concentrate ambient particles in the size range 0.1-2.5 0.1-2.5 (aerodynamicronsmeter; dp) by draerodynamicthrough a series of three virtual impactors.

The series of four virtual impactors produced an empirical ambient fine-mode (≤ 2.5 μm) particle concentration enhancement of 40 60 times ambient levels in the exposure chamber.

The principal components of the ELPI include a unipolar corona discharge, a 13-stage low-pressure impactor, with electrically isolated collection stages and a series of electrometers, which together provide real-time particle size classification and quantification of particulate matter in the size range from 7 nm to 4 μm.

In addition, these observed variations were synchronized with those of the fractions of activity of the aerosol particles trapped at the stage #2 substrate and the backup filter in the impactor, as shown in Fig. 4. Figure 7b compares the time series of the normalized 137Cs(7) (the red line) with that of the Rscale values, and Fig. 7c shows the correlation between Rscale and the normalized 137Cs(7).

Commonly, an MPSS consists of an impactor, a bipolar diffusion charger (often called neutralizer), a DMA, and a CPC setup in series.

Experimental studies involved a series of penetration and perforation tests on 2D beam and 3D panel configurations using a truncated cone impactor with impact velocities up to 10 m/s.

Early Earth's impactor size frequency distributions.

The impactor was made of copper.