Sentence examples for ii solubility from inspiring English sources

We further note that the HA systems may not yet be at Fe(II) sorption equilibrium after 120 days, and that continued slow Fe(II) sorption may lower Fe(II) solubility over longer time scales.

However, the difference in Fe(II) solubility is small (approximately a factor 2, i.e. well within an order of magnitude; Fig. 1a), which is consistent with the EXAFS data showing no evidence for structural or compositional differences between Fe(II)–Al III -LDH formed in the Al III -LDH presence oformedFin. 2A).

The sampling approach, advanced as it was at the time, could only partially validate the Fe(II) solubility phenomena, because the Fe(II) maxima could not be directly observed because the measurements were not obtained in situ.

Various factors like (i) stereo-selectivity of the radicals, (ii) solubility of the extract in different testing systems, (iii) polarity of the solvent, (iv) functional groups present in the bioactive compounds, have been reported to affect the capacity of extracts to react and quench different radicals [ 17].

The effect of choice of n-type dopant (N, P, S) on materials properties like (i) thermodynamics, (ii) solubilities, (iii) geometrical structures and (iv) electronic structures, have then been of a special interest to study more thoroughly.

Concentration of AMFQ in the hydrogels was, respectively, 7.2 and 34 times higher than I and II aqueous solubility, indicating a high increase in aqueous compatibility.

Supersaturation, defined as the ratio between the macromolecule activity in solution and in a saturated state, increases during this process due to the solvent evaporation leading to the (i) increase of protein concentration and very often to (ii) its solubility decrease, due to the increasing concentrations of the precipitant.

RL-HCL comes under class II (low solubility and high permeability) of biopharmaceutical classification system (BCS) with lesser bioavailability [ 5].

(ii) "Being soluble of solubility class at most k" is closed and non-open.

For example, a class I drug might need much less formulation work compared to a class II drug where solubility must be improved (Almukainzi et al. 2014).

Colored dots represent the values of the analyzed property: I viscosity, II KOW, III solubility in water, IV enthalpy of fusion.