The objective of this paper is to identify the reliability of walking experience variable in relation to walkability in two different urban neighbourhoods in Putrajaya.
The management aims at assessing the likelihood of failures through the whole press machine and since it is not possible to have a replacement for the machine, desires to identify the reliability and the risk in whole press by determining the key parts' risk of break down and decisions are made on it.
Objectives To identify the reliability of clinical impact grading by health professionals (i) between professions (inter-rater) and (ii) within professions (intra-rater)) of common prescribing errors and optimisations in critical care patients; and (iii) identify representative clinical impact grades for each example. . between professions (inter-rater) and.
In the remaining part of this section, the word trust is used to identify the reliability of nodes also that may be evaluated in different ways, but, in general, it can be considered as the capability of nodes to respect a service agreement.
Otherwise, the additional conductions were needed to identify the reliability of candidate sequence in other methods [ 14, 20].
The consistency in the control samples between testing times again identifies the reliability of the hysteresis measurements and reflects the non-destructive nature of the mechanical testing procedure.
A psychometric design was used for identifying the reliability and validity of the communication skills instruments used for high-stakes exams for IMG's.
Intraclass correlation coefficients (ICC 1,3) were used to identify the reliability between test and retest angle measure differences based on the within and between subject variances, obtained from output from the ANOVA models [ 23].
Hence, it is important to know the quality of RCTs used in meta-analyses in order to identify the reliability of the evidence that may inform treatment and care in medicine, including treatment in the realm of anesthesiology and pain management [ 4, 7, 12, 15, 16].
Once the design point is identified, the index of reliability can be found using known techniques for structures with independent and dependent random variables, normally and non-normally distributed.
