Sentence examples for identified by values of from inspiring English sources

Quartiles were identified by values of 1 (the lowest quartile) to 4 (the highest quartile), indicating the poorest to wealthiest populations, respectively.

Since the chosen vmPFC region (see below) was identified by values of choice bias that were measured during the scanner session, we will report task details for this session only.

The precedence order of water-using processes, which is crucial for the network design, can be effectively identified by the values of Concentration Potential of Demands (CPDs).

We compute the signed distance of each representative point in the plot of Figure 3 from a set of lines, identified by the values of their slope and intercept (see Section 2).

Markov process, sequence of possibly dependent random variables (x1, x2, x3, …)—identified by increasing values of a parameter, commonly time with the property that any prediction of the next value of the sequence (xn), knowing the preceding states (x1, x2, …, xn − 1), may be based on the last state (xn − 1) alone.

Markov process, sequence of possibly dependent random variables (x1, x2, x3, …)—identified by increasing values of a parameter, commonly time with the property that any prediction of the next value of the sequence (xn), knowing the preceding states (x1, x2, …, xn − 1), may be based on the last state (xn − 1) alone.

A theoretical calculation of pI and molecular weigh on the ExPASy proteomics server (http://www.expasy.org) gave for an ILK N-terminal fragment of 165 amino acids – which is the length comprising the peptides identified by MS – values of 18618.10 Da and pI of 5.95, which are very close to the experimental values obtained in our analysis (Table S1).

Finally, the method is applied to the mode identification of the Floating Production Storage and Offloading (FPSO) single-point mooring structure, the distribution of the modal parameters of single-point mooring structure is analyzed and modal parameters identified by different values of q are compared.

This is as expected since the criteria of the 26 gene list is that the DEGs were identified by all values of d in both TFA and SFA, also including the TFA with d = 0,2, a test being close to the UWA.

Irreplaceability scores may serve as a relative measure of conservation priority, thus assisting in determining equivalence, and areas identified by high values of irreplaceability (e.g., 95%100%%) should be considered no-go areas [ 21, 22].

Disconnected herds were reliably identified by low values of Caco.