Sentence examples for id tip from inspiring English sources

The sample was sprayed through a distal coated fused silica emitter tip (75 µm ID with 15 µm ID tip, New Objectives PicoTip).

At 0.65 m/s in a 1.0 mm id tip, τ = 70 N m−2 which is probably sufficiently lower than the critical shear stress values for the two cell lines to result in the little to no loss of cells observed even for 100+ passes (Fig. 8).

An alternative method of resuspension was by means of an electronic multichannel pipette (EDP®3, Rainin, CA) fitted with 1.0 +/− 2.5% mm id tips and located as above and programmed, based on initial observations of cell dispersion, to withdraw and redispense over a period of ∼2 min for 110 times, 500 μL of suspension at 500 μL/s (0.65 m/s).

Nanoelectrospray ionization was achieved via distal coated Pico Tips™ 20 µm ID, 10 µm tip ID (New Objective).

These results indicate that the ID of the tip has a certain effect on the electrospinning process.

The holes with diameter of about 600-700 μ m were punched by a Biopsy punch (Harris Uni Core, Tip ID 750 μ m, Ted Pella, Inc).

A silicatipTM uncoated needle (20 µm ID, 10 µm tip ID) (New Objective, Woburn, MA) was used with a spray voltage of 1.8 kV, and the capillary transfer temperature was set to 200°C.

Peptides were applied to a precolumn (C18 pepmap100, LC Packings, http://www.lcpackings.com/) connected to a self-packed C18 8-cm analytical column (BioBasic resin ThermoElectron; Picotip 75 µm id, 15 µm tip, New Objective, http://www.newobjective.com/).com/

Peptide digest was first loaded on a Zorbax 300SB-C18 trAgilentlent, Palo Alto, CA) at 6 μL/min for 5 min, then separated on a PicoFrit analytical column (100 mm long, ID 75 μm, tip ID 10 μm, packed with BetaBasic 5 μm 300 Å particles, New Objective, Woburn, MA) using a 40-min linear gradient of 5-35 % ACN in 0.1 % FA at a flow rate of 250 nL/min.

A volume of 5 μL from the reconstituted digests was injected automatically and loaded onto a in-house packed C18 PicoFrit column (75 μm ID/15 μm tip ID, NewObjective, Woburn, MA, USA) packed directly inside the electrospray needle tip using specially designed nanospray emitter tips.

Peptide separations were performed on an nanoAcquityLC system (Waters, Milford, MA) or EASY-nLC II (Thermo Scientific, San Jose, CA) with a PicoFrit (100 μm ID/10μm tip ID, New Objective) column self-packed to a bed length of 12 cm with Jupiter Proteo 90Å C12, 4 μm resin (Phenomenex, Torrance, CA).