Sentence examples for hydrostatic level from inspiring English sources

To the east of the GNSS tide gauge installation (approximately 10 m), three hydrostatic level transmitters (HLT), i.e., pressure sensors, are installed.

The catheter was connected to a Deltran® pressure transducer (Utah Medical Products Inc., Salt Lake City, UT, USA) located at the same hydrostatic level as the mouse, which was connected to the CyQ BMP02 system (CyberSense, Inc., Nicholasville, KY, USA) designed to measure invasively systolic, diastolic, pulse pressure, mean arterial blood pressure (MAP) and heart rate (HR).

The squatting test (successively 1 min standing, 1 min squatting, and 1 min standing) is an original active orthostatic maneuver that leads to the most important and fast variations of the hydrostatic level with posture (9).

Considering actual conditions of the accelerator structure and the assembling place, a new type of sensor of hydrostatic levelling system (HLS) has been designed.

Such a system has been developed at CERN using state-of-the-art technology including 0.1-μm resolution stepping motor drives, capacitive position monitors (in which the position of a conducting wire between two capacitive plates changes) and hydrostatic levelling systems, and has been used in a real accelerator environment to maintain components in position to within 1 2 μm.

In extensional (σ v = σ 1) and strike-slip (σ v = σ 2) stress regimes where σ 3 is horizontal, vertical extension veins may form under hydrostatic levels of fluid pressures in the near-surface (z < 1 2 km), but suprahydrostatic fluid pressures are required for their formation at depths more than a kilometre or so (Secor 1965).

100% polyester and polyester cotton fabrics treated with 4%and7%7% fluorpolymer reach hydrostatic pressure level of more than 20 cm and therefore can be used for level 2 protection as per AAMI barrier classification, whereas 100% cotton fabric can provide only level 1 protection even on application of 7% fluoropolymer finish.

By incorporating the effect of strain hardening on the static yield pressure, we derived an equation relating volumetric creep strain at a constant hydrostatic pressure level to the logarithm of time, which is in good agreement with experimental results.

Because CVP is usually very low, defining the appropriate hydrostatic zero level is important in estimating CVP, but such physiological zeroing can be difficult.

A discussion is presented of the interpretation of using the Dang Van criterion to assess crack initiation for stress response load cycles with low shear stress amplitudes and high hydrostatic stress levels.

Pressure (negative hydrostatic stress) levels were observed for the two test structures Fig. 8a crystalline test structure, without Cu grains by using isotropic elastic constants of Cu from Table 1 and Fig. 8b with polycrystalline Voronoi tessellation based microstructures of Cu using anisotropy in the elastic constants of Cu and textured grain orientation.