Sentence examples for hydraulic channels from inspiring English sources

We designed and developed a forced cooled Nb3Sn superconductor with dual composite hydraulic channels for 10 kA, 10 T, and 4.5 K.

We have investigated analyses of stability and thermal performance of internally forced cooled superconductor, and from the results of these analyses we proposed a new type forced cooled superconductor, which has composite hydraulic channels in the cables in parallel with more open flow channels of much greater hydraulic diameter.

A numerical analysis has been carried out of the stability and thermal performance for this forced cooled Nb3Sn superconductor with dual composite hydraulic channels under 10 T and 4.5 K. From this analysis this superconductor predicts the quite well transient stability margin at 10 T, 4.5 K, and 10 kA.

The best hydraulic channel section makes the maximum flow capacity for the same flow cross-area, and the minimum cross-area and wetted perimeter for the same discharge.

An extensive experimental study is carried out where in the parameters affecting the flow maldistribution such as channel hydraulic diameter, channel flow configurations (U, Z, I type) and chip power are varied to study their effect on the pressure drop and temperature distribution across the parallel channels designed for liquid cooling of a CPU using distilled water.

The new mean is also used to evaluate the operation of parallel heat exchangers, such as are often employed at the hot end of a preheat train; a phenomenon that we call 'thermo-hydraulic channelling' is identified.

The structure had three degrees of freedom as design variables: the elemental volume, channel hydraulic diameter and channel-to-channel spacing.

The volumetric mass transfer coefficients were obtained for various cross-sectional shapes and hydraulic equivalent channel diameters at various flow velocities.

We simulated a case in which a horizontal injection well intersects a steeply dipping fault, with hydraulic fracturing channeled within the fault, during a 3-h hydraulic fracturing stage.

Cunge (1969) developed a method for estimating the Muskingum method parameters from hydraulic and channel geometry characteristics.

Vuohensilta has become something of an online sensation since launching his "Hydraulic Press Channel" in October 2015. .