Sentence examples for hydraulic calculation of from inspiring English sources

This paper sets out to determine a reliable model for the hydraulic calculation of I-RingsTM (IMTPTM equivalent).

Hydraulic calculation of steam water mixture pipelines in Kamchatka came to be used only after 2003 for construction of new pipelines and reconstruction of old ones.

According to the design principle of the spiral case, the wrap angle is set at 245 degrees based on the basic parameters of the hydraulic turbine, and the hydraulic calculation of the spiral case is taken on, then the size of each part is calculated, finally the diffuser single line figure and section are mapped out.

The simulator is intended for hydraulic calculations of steam water mixture transfer (Shulyupin 2007, 2013).

In this paper a methodology for hydraulic calculations of both forced and natural circulation loops is presented.

The advantages of the algorithm are significant not only for specific computer programs that refer to reservoirs, but also for computer programs relevant to hydraulic calculations of reservoirs and associated structures.

The thermal hydraulic calculations of the 10 MW high temperature gas-cooled-test module (HTR-10) are among the most important indications to judge the reactor performance under design conditions.

The ITERTHA code is also benchmarked against the thermal-hydraulic calculation of the outer divertor of the Fusion Ignition Research Experiment, FIRE for an incident heat flux of 20 MW/m2 and coolant flow velocity of 10 m/s in a cooling channel of 8 mm diameter with swirl-tape inserts of 2 ratio and 1.5 mm thickness.

This paper presents the results of thermal-hydraulic calculation of "Steam Line Break" analysis at full power reactor for VVER-1000/V320 units at Kozloduy Nuclear Power Plant (KNPP), done during the development of symptom based emergency operating procedures (SB EOPs) for this plant.

This paper presents the results of thermal-hydraulic calculation of accident scenarios that involve the trip of main coolant pump (MCP) in case of Small break loss of coolant accident (SB LOCA) for WWER-440/V230 units at Kozloduy Nuclear Power Plant (KNPP), done in support of the development of Symptom Based Emergency Operating Procedures SB EOPss) for this plant.

According to the hydraulic calculation principles of the orifice outflow, the discharge capacity of the columnar reversing gate under the partial opening condition was calculated and checked.