Sentence examples for hot feed flow from inspiring English sources

The results indicated that increasing feed temperature, hot feed flow rate, and module depth on the cold side led to increase permeate flux.

Results showed that, for all spacers, the heat transfer coefficient increases with hot feed flow rate and that the combination of attack angle 45° and filament angle 90° gave the highest heat transfer.

A reduction of the total air gap pressure to the saturated water vapour pressure of the hot water feed flow temperature of 65 °C, raises the flux by a factor of three.

The laboratory scale unit was tested in order to investigate the effect of operating conditions, i.e. hot feed temperature and flow rate, on the process performance, with particular attention paid to parameters relevant to the design of the system coupled with solar energy.

It is found that the permeate flux higher than 50 kg m−2 h can be obtained in the proposed AGMD-based finned tubular membrane module with 11 grooves when the operating conditions are controlled at both hot feed and cold water flow rates of 5 L/min, hot and cold temperature of 353 K and 303 K, respectively.

Distillate quality was excellent (in the range of 2 5 μS cm−1) and practically not affected by feed flow rate, hot inlet temperature or feed salt concentration.

The new module design includes a tangent directional and rotational inlet turbulent flow of hot feed and a partial contact between the membrane and the cooling plate in a small air gap.

The effects of operating conditions including the feed flow rate, feed temperature, cold temperature, and temperature difference between the hot feed and cold solution are investigated on the permeate flux.

In this case, the feed flow can be delivered to a specific cross-section of column both of cold and of hot columns.

The control variable was feed flow.

Change in feed flow rate usually affects grade and recovery.