Sentence examples for homogeneous experiments from inspiring English sources

To improve the knowledge on the rheology of sheet molding compounds (SMC) during compression molding, a specific rheometer was designed, allowing to perform homogeneous experiments on SMC specimen under various mechanical loading, strain rates and fiber contents.

Homogeneous experiments with 100 mg/L Fe2+ or Fe3+ were also performed leading to about 50% COD reduction; this increased to about 65% when H2O2 was added, i.e. simulating a Fenton reaction.

The best-case scenario is when channel condition and QoS requirements are homogeneous (experiment I), whereas the worst case in terms of the gap in utility corresponds to the homogeneous channel and non-homogeneous QoS requirement case (experiment III).

To validate this mechanism, rapid compression machine (RCM) was used to conduct the quasi-homogeneous experiments to measure the total ignition delay time at various effective temperatures (640 865 K) for three different PODE3/O2/N2 mixtures (ϕ = 0.5, O2 N2 = 1 8; ϕ = 1.0, O2:N2 = 1 15; ϕ = 1.5, O2 N2 = 1 20) and two different effective pressures (10 bar, 15 bar).

However, the dissolved ferrous iron concentrations in these homogeneous control experiments are significantly higher than for the pyrite experiment shown in Figure 6, see Table 2. Iron concentrations decrease in experiments where iron was added to the beginning of the experiment, but increase when pyrite is added to an RNA solution.

In literature it is proposed, on the basis of homogeneous tracer experiments only, that the velocity ratio Ψ (the ratio between the oscillatory velocity and the superficial velocity of the imposed flow) is sufficient to identify optimal operating conditions for plug flow in COBC.

One of the first approaches allowing homogeneous binding experiments was based on the optical separation of bound and free fluorescent molecules, the so-called laser-scanning imaging (LSI).

Second, our description of ligand-receptor interaction assumes that ligand and receptor distributions are continuous and homogeneous, while experiments indicate the formation of receptor micro-clusters [ 66], possibly as part of lipid rafts [ 47].

This technique was used to investigate COM homogeneous nucleation; experiments were performed at a constant supersaturation with respect to COM (σCOM) of 0.745 at pH 6.5 and with 0.15 M ionic strength, at 37 °C.

This Homogeneous Reactor Experiment (HRE) was affectionately dubbed "Alvin's 3P reactor" because it required a pot, a pipe, and a pump.

This study indicates that 2D simulations are sufficient to understand integrated features of variable density flow in homogeneous sand column experiments.