Sentence examples for hole zone from inspiring English sources

The authors [4], however, confined themselves to determining the temperature and pressure fields in the reservoir, while the dynamics of growth of the hydrate layer in the well was determined within the framework of the model proposed in [1], i.e., the problem of determining the possibility of hydrate formation in the bottom hole zone was not even posed.

The following parameters were analysed: latency to target [time from start of the trial to first entry into the target hole zone (s)], total distance moved (cm) and error frequency (number of visits to other holes than the target hole).

To improve the cost-efficiency of the deposit development, the project provides the use of HF, acid HF and HAT, as well as chemical processing of well bottom hole zones in order to reduce the oil viscosity.

Free water (phase III) where water is fixed by one hydrogen bond between polypeptide chains or fixed in the hole zones at the end of the polypeptide chain, and finally transition water (phase IV), where water is bound between the fibrils [21, 22].

Free water (phase III) where water is fixed by one hydrogen bond between polypeptide chains or fixed in the hole zones at the end of the polypeptide chain, and finally transition water or unperturbed bulk water (phase IV), where water molecules are bound between the fibrils [10, 11].

The all-atom Hamiltonian replica exchange molecular dynamics simulation shows that these charged sidechains are oriented toward the fibril "hole zones" and significantly template nucleation with amorphous Ca Pi phase, ∼1.3 1.6 nm in size, thus explaining the empirical observations that Ca Pi nucleates principally in these regions.

The helical region extends through the hole-zone to the surface and acts as a flexible hinge, hindering additional crosslinking, and thereby limits the size of the fibril [ 29].

We have visualised/quantified the hole and zone of cell death (ZCD) in cartilage after drilling/insertion of various articular screws.

The study emphasis is placed on the effect of biaxial loading and the bolt hole plastic zone on the fatigue crack growth from the bolt hole when the disc is subjected to cyclic rotation speed.

A solution of the ratio of the stress intensity factors under biaxial loading to those under uniaxial loading for a crack entirely or partially embraced by the bolt hole plastic zone is obtained.

The crack propagation rate predicted by the modified crack growth model is found to correlate better with the experimental data measured in the spin rig test than that predicted by the conventional model which simply ignores the biaxial load and the bolt hole plastic zone effect.