This architecture has been conceived with the aim of achieving a high operation frequency and high throughput without increasing the hardware complexity.
The comparison showed that all the three major performance features, including lower bit error rate, higher operation frequency, and higher temperature operation are improved in the proposed optimized design.
Based on the numerical simulations, it is observed that even for a centralized ARLWD tool, the geosignal acquired in a conductive mud filled borehole (less than 0.1 Ω m) with a short transmitter-receiver spacing (16 in) and high operation frequency (2 MHz) is distorted, which indicates the ARLWD tools prefer an oil-based drilling mud borehole.
The performances of the A0 mode AlN/SiC plates were compared with those of the enhanced coupling (K2 = 4%) ZnO/SiN plates for liquid sensing applications: the former higher operation frequencies and remarkable endurance to high temperature and chemical etching, make it the ideal candidate for the development of elettroacoustic devices able to survive to harsh environment.
Improving dexterity, that is, achieving high operation frequencies and manipulation accuracy; Providing patients with exteroceptive and proprioceptive information; Finding ways to embed sensors in an artificial skin that is cosmetically acceptable and mechanically compliant; Developing shared control algorithms that make it possible to identify and act according to voluntary motor commands.
More specifically, the experimental results with a number of DSP applications show the effectiveness of the introduced methodology, as we achieve on average 25% higher maximum operation frequency and 39% lower power consumption compared to the uniform 3-D NoCs.
The structural stiffness of the coil design provides a high resonance frequency, above the operation frequency range f= DC…1.2 kHz.
Owing to pick-up coil's flat design, relatively low operation frequency and high relative resolution this method has advantages, compared to others, which become crucial at non-destructive studies with thin flat HTS materials (with a small signal), especially near Tc (at the start of "Cooper" pairs' formation).
In this paper, the HP-PWM signal drives an underwater acoustic transducer (UAT) with a fixed operation frequency and High-Q (as shown in Fig. 2).
