Sentence examples for highest mass fraction from inspiring English sources

As an example of the small effect of ice formation on the energy budget of the plume we consider the plume from Eyjafjallajökull at 2100 (note all times given are UTC) on 13 May 2010, when our model predicts the highest mass fraction of condensed water over the course of the second phase of the eruption to occur.

Aggregate makes up a high mass fraction in asphalt pavements.

Although the formulation with higher mass fraction of HFA 134a can generate smaller droplets, it cannot produce steady puffs with relatively low mass flow rate.

Since in the new geometry the coolant and moderator circuits are separated, compared to previous plans, using the nanofluids with higher mass fraction of nanoparticles is applicable.

Equilibrium swelling at pH = 7 was noticeably enhanced in gels having a high soluble fraction and high mass fraction of dendrimers.

A part of alkyl side chains are transformed into phenolic hydroxyl group and ether linkage under the effect of fusainization, which leads to the relatively higher mass fraction of C O in SDI.

Improved fits to the observations require the innermost plume mantle to be compositionally distinct from the ambient asthenosphere; for example, by having a slightly higher mass fraction of EC (13 16%), or with DC having slightly higher 87Sr/86Sr and La/Sm.

It is also detected that the working fluid with the higher mass fraction of ethylene glycol has lower values of Nusselt number, and the effect of that on the friction factor is not considerable.

In general we observed that, by using the two-phase synthesis, a high mass fraction of the cuboctahedral crystalline structure can be obtained (the mass fractions of three structure types are about the same) and in addition, a better modulation of stabilized gold nanoparticle sizes in the range (2.5 ÷ 9) nm, when Au/S molar ratios have been varied, is achieved.

This anomalous behavior can be attributed to the poor quality of specimens due to fiber agglomerations in some places due to higher mass fraction which caused poor penetration of resin into the fiber mat resulting in inefficient load transfer.

For rheological characterisation, amplitude sweep tests performed on HIPE samples with a high mass fraction of dispersed phase (93.5 wt%) show that the strain behavior, especially the yield strain (εy) and crossover strain (εc), are almost independent of the droplet size and polydispersity.