Sentence examples for highest formation of from inspiring English sources
The maximum degradation is achieved in the basic medium, which might be due to the highest formation of hydroxyl radicals (Saeed et al. 2015).
It is found that the Bi-2223 polycompoundine compreparedepared under 300 MPa pressure load at 840 °C for 48 h presents the highest formation of Bi-2223 phase due to the considerable elimination of the impurity scattering and lattice strain in the crystal structure.
Microporous materials, due to the presence of shape-selectivity effects limiting the polymerization of glucose to humic-type species show the highest formation of glucose and HMF with respect to the sulphated zirconia supported over mesoporous silica (SBA-15) and homogeneous heteropoly acids.
Harnack et al. [ 33] suggested that a ratio of 1/1 would lead to the highest formation of n-3 LC-PUFA, given that the conversion of n-3 fatty acids into higher homologues may depend on the ratio of ingested n-6/n-3 facidsacids.
n-Butanol addition, however, shows no significant reduction effects or even higher formation of soot precursors.
The monolith catalysts synthesized by slurry with Ludox and direct synthesis using citrate method exhibited a high formation of syngas.
When the potential over the hydroxyl surfaces is very high, formation of stable complexes does not occur and the enzyme does not act intensely.
The lower viscosity and shear stress with respect to shear rate observed in frequency condition of 574 kHz with 50%% power input was due to higher formation of hydroxyl radicals and disintegration of asphaltene flocs.
Beyond 10% blending, there is an increase in the volume of permeable voids due to the leaching of LP (unreacted) or higher formation of Ca(OH 2 which is confirmed by XRD studies.
There are other studies also showed that at mid-frequency level, there is significant rise in the number of cavities formed resulting higher formation of hydroxyl radicals and consequent disintegration of molecules [11].
For the different catalytic runs in a batch reactor, a higher formation of hydrocarbons, alcohols, ketones, and furans was observed when the mass of catalyst was increased.
