Sentence examples for highest displacement at from inspiring English sources

The highest displacement at impact locations was observed due to strike of F4.

Results demonstrated that, similarly to FCD influence, a physiological initial porosity of the tissue (Φ0 w = 75% of water content) yielded the highest displacement at the upper surface of the sample, which exhibited a sharp increment within the first 200 seconds of simulation and peaked at 0.143 mm.

We show that Class A, C, and D fault zones were formed by progressive cataclasis, leading to the development of a foliated gouge core and wide damage zone at the highest displacement magnitudes.

Onset of tube local buckling was observed at higher displacement ductility levels (µ = 3) for specimens using thicker tubes (D/t = 48) than for those using thinner tubes (D/t = 95).

In this paper, several experimental analyses have been performed, complemented by the use of Abaqus/CAE finite element analysis, in order to develop a high-power ultrasonic cutting device for bone surgery using a new configuration of cymbal transducer, which is optimised for operation at high displacement and high input power.

The experimental results demonstrated that the externally bonded strengthening was able to prevent a brittle failure and it was not affected by debonding; ultimate load of the retrofitted wall almost doubled with respect to the unreinforced configuration, despite complex stress state, and that the failure was governed by shear sliding at higher displacement levels.

This higher displacement of corner column at a wind incidence angle of 15° is due to the action of sway motion and torsion loads developed on the building as a result of non-uniform pressure distributions on different walls of the building.

Further fatigue parameters (Nf(crack) and Nf NLC)) indicated a swifter deterioration of HMA mixture at a higher displacement (cooling) rate.

In medium and fine granular SiC, the shear localization at sufficiently high displacement (>150 μm) leads to the formation of a thin layer (5 20 μm) of well-bonded material.

At 6 weeks of treatment, all the treatment groups showed significantly higher displacement value than the OVX group at the corresponding treatment duration.

During maximum power trials in July 1913, the battlecruiser achieved 96238 shp for a speed of 27.97 kn while at the unusually high displacement of 29660 LT.